Rev.1.0: 8 Mar 2001 STTのマップデータ取得マニュアル A Manual for Obtaining STT Map Data H. Hara Yohkohはジャイロの劣化でZ軸回りの安定度がいくらか悪くなってきている。あ る時点の衛星のZ軸回りの位置情報を、STTのCCD画像上にあるカノープス位置か ら直接得るために、 STTのマップデータを毎日取得することになった。このた めいくつかのOGをOP中にマニュアル操作で加える必要がある。 The pointing stability around Z axis of Yohkoh is degrading due to the degradation of a gyro. Under this circumstance the acquisition of STT MAP data in every-day basis have been decided to obtain a direct position of Canopus located on the STT CCD. We need to add a sequence of OG commands in OP manually. ● 一連のOGをOP中に入れる時間帯は以下のとおり。 The sequence of OG commands shall be inserted to OP in a period satisfying the following conditions: ・カノープスが衛星から見えている期間に実施する The sequence shall be conducted during a period in which Canopus can be seen from Yohkoh. ・放射線帯中は避ける Avoid a period of radiation belts. ・鹿児島の運用局KSCで観測データが落ちるようにする The data shall be obtained at KSC. - 望ましいのは、1パス目の前 A period prior to the first KSC contact is preferable. - 1パス目前によいウインドウがないときは、KSCパス間に行なう A period between KSC contact passes if there is no good window prior to the first contact. ・一連OGの間でモードが切り替わらないようにする A command for mode/bit change shall be prohibited in the sequence of OG commands. ● STTマップデータ取得用のOG群 OG commands for obtaining STT MAP data Name of OG OG No.[Dec] Interval ---------------------------------------------- ・CMP OBS ON 30 1 ・STT EVENT OF 35 1 ・STT MAP START 117 8-10 ・STT MAP END 118 1 ・STT EVENT ON 36 1 ・CMP OBS OFF 31 Depends on the case ----------------------------------------------- 注)STT MAP STARTからMAP ENDまではACS-Mとなるため、観測は一時的に 中断される。 Since the mode becomes ASC-M in a period between STT MAP START and STT MAP END, observations are interrupted by this sequence when it is a day time.